U of I Extension
Summer planting of trees, shrubs, and evergreens
Send a link to a friend
[June 28, 2019]
If you think you missed the spring
planting window for your favorite tree, shrub, or evergreen, do not
despair. |
Summer planting can be done with some extra care at
planting time and the weeks following. Container-grown plants have
the greatest flexibility of planting times since all the roots that
the plant has are contained in the pot. Balled and burlapped trees,
shrubs, and evergreens that were dug for the spring planting season
are also suitable for planting. The plants can begin to establish
themselves in the yard before the fall planting season gets here and
long before cold weather sets in for the winter.
If you are planting a flowering ornamental like crabapple,
serviceberry, or another favorite bloomer, you can expect to see
blooms this year (if it is not too late) since the flower buds were
already on the tree for 2019. That may not be the case for 2020. The
tree will be directing all resources to establishing a strong root
system instead of creating flower buds. Once the root system
“catches up,” flower bud production will resume. This is exactly
what happens when planting fruits trees too.
University of Illinois Extension horticulture educator Richard
Hentschel says, “Do not think anything is wrong, it is just what
happens.” While shade trees also bloom, the flower is insignificant
and the lack of blooms in the planting year often goes unnoticed.
Proper planting will help ensure your trees, shrubs, and evergreens
make it through their first winter in your home landscape. Trees
should last many decades, while foundation-sized shrubs and
evergreens should have a lifetime of 12-15 years before needing to
be replaced. Needled evergreen trees should last for decades as
well. Research done by the green industry suggests that if properly
planted, shade and evergreen trees will easily be there for future
generations.
The hole dug should be 2-3 times the width of the
container or soil ball at the top 1/3 of the hole, but does not have
to be that wide at the base of the container or soil ball at the
bottom of the hole. The extra width at the top ensures the feeder
root system can expand easily and establish quickly.
[to top of second
column] |
Do not over-amend the soil you will be using to backfill around
the container or soil ball. Strong textural differences make it hard for the
roots to leave the container soil or root ball and move out into the surrounding
soil.
Next, Hentschel says, be sure the container or root ball is not
too deep when put into the hole. The research mentioned earlier also suggests
roots can grow down into the soil to the correct levels, but cannot move upwards
very quickly. That can delay proper establishment.
With container-grown trees, the root-flair area can easily be seen. The flair
should be at or slightly above the soil line when planted. That same root flair
is there on a balled and burlapped tree, but can be harder to see. If in
question, plant a balled and burlapped tree a little higher by an inch or two to
ensure the tree is not planted too deep. It is best to identify the root flair
before you dig the hole so it is no deeper than necessary.
The biggest difference in spring and fall planting compared to summer is the
critical need to manage the watering for a summer planting. Water the plants in
well at planting time and check for soil moisture in the container or root ball
area in about 5-7 days (sooner for containers, later for soil balls) to be sure
soil moisture is adequate. After that, Hentschel says, check every few days,
knowing that watering is all weather-dependent. Hot, dry air will pull more
water out of the plant. The only water available to new plants is when you water
at the base of the plant and within the planting hole. The plant will not be
able to reach out any further until new roots are created.
[Richard Hentschel, Horticulture
Educator, University of Illinois Extension] |